User's Manual
Table Of Contents
- 1: Introduction
- 1.1 Documentation notes
- 1.2 Product introduction
- 1.3 General product handling and operation
- 1.3.1 Powering on/off and sleep mode
- 1.3.2 Attaching, detaching, and handling modules
- 1.3.3 Attaching the Wi-Fi antenna
- 1.3.4 Attaching the strap
- 1.3.5 About the touchscreen display
- 1.3.6 Selecting the active interface
- 1.3.7 Starting a function or test
- 1.3.8 Stopping a test
- 1.3.9 Saving results
- 1.3.10 Interpreting results
- 1.4 Maintenance
- 1.5 Technical support
- 2: Wi-Fi Testing Menu
- 3: 10/100 Testing Menu
- 4: System Menu
- 5: IP and Video Testing
- 5.1 IP Network Setup
- 5.2 Connection Information
- 5.3 Ping
- 5.4 Traceroute
- 5.5 Web Browser
- 5.6 IP Video testing
- 6: Specifications
Base Unit User Guide Issue 1 Tech-X Flex™
5-10 5: IP and Video Testing
Intro
Wi-Fi
10/100
System
IP/Video
Specs
IP Port UDP port of the video stream. Similar to the IP Address, this must be the
destination port in the UDP packet header. If you selected a channel from the
channel guide, this field is automatically populated.
Optionally, you can select As IP Add from the drop-down list which indicates to
ignore the port and use the IP address exclusively for identifying video stream
packets. In the case of unicast streams where packets are addressed to a
network device such as an STB, it can be more difficult to determine the UDP
port than the IP address of that device. Therefore, this option allows traffic
analysis based on IP address alone. While the STB may be receiving some data
that is not part of the video stream, it is likely that most traffic will be video data
that qualifies for analysis.
Duration Duration of the test in seconds, or Continuous to run the test until manually
stopped.
Interval Interval at which to report a full set of current measurement results, applicable to
continuous tests only.
Encapsulation
Method
Encapsulation type of the stream under test.
• RTP
• UDP
IGMP Version Version of IGMP to use for multicast join/leave requests. This must reflect an
IGMP type in use on the network where the request is made.
Options include:
• 1 - IGMP version 1
• 2 - IGMP version 2
• 3 - IGMP version 3
• D - Dynamic. The unit attempts to monitor existing IGMP traffic on the network
to determine the type in use.
Codec Video codec used for the stream under test.
• MPEG2
• MPEG4
• H264
Table 5-6 Video QoS test - Setup parameters
Parameter Description