JKS6 GPS Tracking Device
Table of Contents 1. GETTING STARTED ............................................................................................... 6 1.1 UNPACKING INFORMATION ......................................................................................6 1.2 INTRODUCTION......................................................................................................6 2. PORTS AND LED INDICATORS............................................................................... 7 2.1 PORTS ........................
Declaration of Conformance Manufacturer: Name: Wistron NeWeb Corporation Address: 20 Park Avenue II, Hsinchu Science Park, Hsinchu 308, Taiwan, R.O.
Safety Instruction Only authorized service providers shall replace the battery in this device. Do not disassemble, open, crush, bend, deform, puncture, or shred. Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, expose to fire, explosion or other hazards.
Regulatory Statement Specific Absorption Rate information This mobile device meets the government’s requirements for exposure to radio waves. Your mobile device is a radio transmitter and receiver. The exposure standard for mobile devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit adopted by Europe is 2.0 W/kg averaged over 10 grams of tissue.
FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
1. Getting Started 1.1 Unpacking Information Included in the package are the following items: JKS6 GPS Tracking Device Cable x1 1.2 Introduction The JKS6 is a self-contained tracking device that combines GPS location with LTE Cat. 1 and 3G network connectivity. The device responds to user or server requests. Data reports contain all location data and the system status. The device comes pre-configured from the factory, ready to use.
2. Ports and LED Indicators 2.
2.
3. Installation The image below shows how the JKS6 tracking device is installed.
4. Specifications Hardware & software • • • WAN module: M14QS – LTE CAT1(B2/4/5/12/B25/26), B4/12 are roaming bands for ATT – GPS/GLONASS/aGPS USIM 3FF Microcontroller – STM32 F030 – ADC/UART/SPI/I2C/GPIO – 5 power mode control Backup battery • Li-ion battery – Spec: 170 mAh/3.7 V – Max discharge current: 5 C – Operation temperature range: –10°C to +60°C Buzzer • • • • Electro-magnetic buzzer Operating voltage: 3 V to 6.
