Operation Manual

7
Fitness Bike
XBR25
1. Install the Seat (61) on the Seat Carriage (4) with four Phillips Head Screws (98). Tighten with the Phillips Head
Screw Driver (114).
2. Attach the Seat Handle Bar (6) to the Seat Carriage (4) with the four Hex Head Bolts (71), four Flat Washers
(77), and four Nyloc Nuts (89). Tighten with the wrenches provided (112 & 132).
3. Plug the Hand Pulse Sensor Cables (27) into the left side of the rear plastic cover.
HARDWARE
STEP 3: Seat & Handle Bar
#98. M6 x 15mm
Phillips Head Screw
(4 pcs)
#77. 3/8” x 19 x 1.5T
Flat Washer
(4 pcs)
#89.3/8” x 7T
Nyloc Nut
( 4 Pcs)
#71.3/8” x 1-3/4”
Hex Head Bolt
( 4 Pcs)