Operation Manual

7
Fitness Bike
XBU55
1. Run the two hand pulse wires (26) into the hole in the handle bar mounting plate and out through the hole in
the console plate. Remove the black plastic cover from the handlebars by cutting the plastic tie.
2. Install the Handle Bar (3) onto the Console Mast (2) with two Hex Head Bolts (51), two Flat Washers (72),
and two Split Washers (103), being careful not to pinch the hand pulse wires. Tighten using the Wrench (100).
Snap the black plastic handlebar cover over the joint.
HARDWARE
STEP 3: Handle Bars
#51. 5/16” x 5/8”
Hex Head Bolt
(2 pcs)
#72. 5/16” x 18 x 1.5T
Flat Washer
(2 pcs)
#103. 5/16” x 1.5T
Split Washer
(2 pcs)