Operation Manual

Fitness Bike

XBU55

1. Insert the Computer Cable (29) and two Hand pulse cables (26, 28) into the connectors in the back of the

Console (34). Install the Console (34) onto the Console Mast (2). Install the four Phillips Head Screws (58)

with the Phillips Head Screw Driver (93).

2. Install the Front Stabilizer Cover (40) and the Rear Stabilizer Cover (41) onto the Main Frame (1) with four

Phillips Head Screws (58). Tighten using the Phillips Head Screw Driver (93).

3. Install the Pedals (45L, 46R) onto the Crank arms (16L, 16R). Remember that the left pedal has a reverse

thread and will be screwed into the crank in the opposite rotation from normal threads. There is an “L” stamped

into the end of the threaded post of the left pedal and an “R” in the right. Make sure to tighten the pedals as

much as you possibly can. It may be necessary to re-tighten the pedals if you feel a thumping while pedaling the

bike. A noise or feeling such as a thumping or clicking is usually caused by the pedals being too loose. Tighten

using the Wrench (92).

4. Install the Seat mount slide (7) (post at the front) onto the track on top of the seat bracket (6) by sliding a Flat

Washer (71) onto the seat adjustment knob (86), then slide it through the slots of each and attach a ange nut

(8) to the end. Install the seat (19) onto the seat post by securely tightening the nut on each the side, below the

seat.

5. Install the Drink Bottle Holder (116) onto the Console Mast (2) with two Phillips Head Screws (58). Tighten

using the Phillips Head Screw Driver (93).

HARDWARE

STEP 4: Console, Seat, Covers & Pedals

#58. M5 x 12mm

Phillips Head Screw

(10 pcs)