Owner's Manual

10
XBU55 STEP TWO
HARDWARE FOR STEP 2
PART TYPE DESCRIPTION QTY
51 BOLT
5/16”XUNC18X5/8”
7
72 FLAT WASHER
Ø5/16” × Ø18 × 1.5T
6
99 CURVED WASHER
Ø5/16” × 19 × 1.5T
1
1. Gather HARDWARE FOR STEP 2.
2. Unravel the COMPUTER CABLE (29)
and snake it through the CONSOLE MAST
COVER (38) and the CONSOLE MAST
(2) until the cable connector comes out
the top opening of the console mast. BE
SURE NOT TO PINCH THE CABLE
OR DAMAGE TO THE ELECTRONICS
MAY OCCUR. Slide the PLASTIC
COVER (38) onto the console mast,
ensuring the correct orientation of the cover.
3. Install the CONSOLE MAST (2) onto the
MAIN FRAME (1) with 7 BOLTS (51), 6
FLAT WASHERS (72) on the side bolts
and 1 CURVED WASHER (99) on the
front bolt. Tighten using the WRENCH
(100).