Operation Manual

XBR95 & XBU75

STEP 4: CONSOLE, SEAT, PEDALS AND BEAUTY COVERS ASSEMBLY

1. Insert the Computer Cable (29), handlebar switch cable (110) and two Hand pulse cables (26)

into the connectors in the back of the Console (34).

2. Install the Console (34) onto the Console Mast (2) with the four M5x12mm Phillips Head

Screws (58).

3. Install the Front Stabilizer Cover (40) and the Rear Stabilizer Cover (41) onto the Main Frame (1)

with the four M5x12mm Phillips Head Screws (58).

4. Install the Pedals (45 L, 46R) onto the Cranks by using 13/15mm Wrench (92). Remember that

the left pedal has a reverse thread and will be screwed into the crank in the opposite rotation

from normal threads. There is an  stamped into the end of the threaded post of the left pedal

and an  in the right. Make sure to tighten the pedals as much as you possibly can. It may be

necessary to re-tighten the pedals if you feel a thumping during pedaling the bike. A noise or

feeling such as a thumping or clicking is usually caused by the pedals being too loose.

5. Install the Seat mount slide (7) onto the track on top of the seat tube with the seat post facing

forward. Install the nut plate (8) into the seat slide behind the seat post. Install the flat washer

(71) onto the for/aft adjustment knob (86) and screw into the nut plate from underneath the seat

tube track. Install the seat (19) onto the seat post by using the 12/14mm Wrench (100).