Treadmill User Manual

XT485 Treadmill

1. Install the four speed nuts (128) onto the tabs of the frame.

2. Take the Left and Right upright tubes (part numbers 5 & 4) and slip the upright covers (67 & 61

left, 66 & 62 right) onto the tubes (observe the cover orientation is correct). Connect the Middle

Console Cable (50) that exits from the bottom of the right upright tube with the lower Console

Cable (49). NOTE: Partially tighten all bolts in this step. This will allow for easier

console assembly.

3. Insert Right and Left Uprights (4) and (5) into the Frame Base (2) and attach with eight Button

Head Socket Bolts (130) using the Allen wrench/screwdriver (131). Attach two more Button

Head Socket Bolts (130) and two Flat Washers (147) on the inside surface of the upright tubes.

Be careful not to pinch the wire when installing the upright.

UPRIGHT TUBE ASSEMBLY

#130. 5/16” x 15mm

Button Head Socket

Bolt (10 pcs)

#147. 5/16” x 18 x 1.5T

Flat Washer

(2 pcs)

HARDWARE

#128. M5 Speed Nut

Clip (4 pcs)