Specification

The Ultimate in Distribution Efficiency
The life and efficiency of a heating or cooling system is greatly
dependent on clean system water. Dirt in the system can cause
increased component wear and frequent breakdowns. Corrosion,
pump and control valve wear, and reduced efficiency result in
increased maintenance, unnecessary costs and dissatisfied owners.
Strainers and filters do the job, but if not cleaned on a regular basis,
they cause low flow rates and, eventually, blockages.
There is a solution!
A system without dirt is possible. There is a unique device that will
remove dirt down to the smallest particle. It works continuously
and results in less maintenance, fewer costs and satisfied owners!
The name:
SPIROTRAP
The Spirotrap’s construction is similar to the Spirovent. The patented
Spirotube, core of the Spirovent, is also the core of the Spirotrap. In
the Spirotrap, the Spirotube creates a low velocity area that forces dirt
particles to sink to the dirt collection chamber at the bottom of the unit.
Because the dirt is collected outside of the main flow, blockages do
not occur, and the Spirotrap’s pressure drop remains constant.
The benefits are clear!
The Spirotrap is so much more than your traditional separator!
The unique construction of the Spirotrap dirt separator allows for quick
and simple dirt removal while the system remains fully operational,
whereas traditional products need to be taken apart for cleaning.
There are no strainers, filters or replacement parts to get clogged!
Flow remains constant without the high pressure drop.
Clearly beneficial, clearly Spirotrap!
Advantages to the Installer and End-User
c
Virtually no maintenance.
c
No replacement filters to get clogged.
c
Dirt can be flushed while system is fully operational.
c
No bypass or isolating valves required.
c
Will not block the flow.
c
Minimum pressure drop; always constant.
The Key Difference
Spirotrap’s unique construction allows for the removal of small dirt
particles with a specific weight heavier than water. The patented
Spirotube, the core of the Spirotrap, creates a low velocity area that
forces dirt particles to sink to the dirt collection chamber at the bottom
of the unit. The Spirotrap works continuously and is not affected by the
trapped dirt. Blockages are impossible because the dirt is collected at
the bottom of the unit.
Clean System Water throughout the Life of the Installation
The unique Spirotube is the core
of the Spirotrap. Designed to allow
even the smallest dirt particle to
break free of the flow path and drop
to the collection chamber.
Threaded, sweat and press fit
connections available.
Solid brass construction for
extended service life.
Large collection chamber reduces
the need for frequent cleaning.
Drain valve for flushing out the dirt.
1
2
3
Radiator Radiator
Boiler
Dirt
Separator