User Manual

Phonitor

Be very careful to check that the rear chassis power selection switch

is set to the correct local line voltage position before using the unit

(230 V position: 220-240 V/50 Hz, 115 V position: 110-120 V/60 Hz)!

When in doubt about a source, contact your dealer or a professional

electrician.

Before connecting any equipment make sure that any machine to be

connected is turned off. Follow all safety instructions from page 5.

Place the unit on a level and stable surface. The unit’s enclosure is EMC-

safe and effectively shielded against HF interference. Nonetheless, you

should carefully consider where you place the unit to avoid electrical

disturbances. It should be positioned so that you can easily reach it,

but there are other considerations. Try not to place it near heat sources

or in direct sunlight, and avoid exposure to vibrations, dust, heat, cold

or moisture. It should also be kept away from transformers, motors,

power amplifiers and digital processors. Always ensure sufficient air

circulation by keeping a distance of 4-5 cm/2 inches to other units and

to the sides of the unit.

Before You Begin

Make sure the Volume control is turned hard left before you power up

the unit. Now control Volume. Note that too high levels can damage

headphones and hearing!

Hook Up