Owners Manual

Control Elements

Gain

The amplitude setting ranges from -20 dB up to +20 dB. This means that you can increase

or attenuate the amplitude to a maximum of 20 dB. The maximum increase or attenuation

also depends on the selected Q-Characteristic.

1/4 Gain

Thanks to the 1/4 Gain-Switch, you can reduce a maximum increase or attenuation of

the amplitude by the factor 3/4, which regulates the potentiometer from max +/- 20 dB

to +/-5 dB cut. This gives you the possibility to perform small corrections, as common in

Mastering, in a very accurate manner. Thanks to the preciseness and sensitivity of the

1/4Gain-Switchyoucannelycontrolandworkonthesoundmaterialwiththedetented

potentiometers.

Frequency

Eachchannelprovidesvefrequencybands.Allbandsarefullyparametricandcanin-

dependently be activated or deactivated. The workable frequency range stretches from

10 Hz to 24 kHz.

Frequency Range:

• LF (Low Frequencies): 10 Hz bis 330 Hz

• LMF (Low Mid Frequencies): 33 Hz bis 1 kHz

• MF (Mid Frequencies): 128 Hz bis 4,1 kHz

• HMF (High Mid Frequencies): 310 Hz bis 10 kHz

• HF: (High Frequencies): 760 Hz bis 24 kHz

LF, LMF, MF, MHF, HF -Button (orange)

Thesebuttonsswitchthe10lterbandson(buttonlightsup)oroff(lightoff).

Youcanadjustthebandwidthfrom0.08Qto5,8QinProportional-Qmode,0,6Qto15Q

in Constant-Q mode – this maximum value allows to perform corrective applications with

maximum precision in Constant-Q mode.