Installation Guide

! ! !
!
835 VAN SINDEREN AVENUE BROOKLYN, NY 11207 | 888.541.3840 | [e-mail]
Drilling
If possible, drill holes before installing tile. Drilling from both sides can ensure a cleaner
finish if the hole will be visible after installation. Using a new diamond coring bit (for large
holes) or spade bit (for small holes) with a diamond tip made for glass drilling will give the
best results. Lubricating the bit and tile surface with a continuous spray of oil/water mix will
prolong the life of bits and provide a better-finished edge. When possible, the use of a jig
will ensure precise placement of holes to be drilled.
When drilling holes for anchoring bolts, plumbing or any other dissimilar material always
ensure a minimum of 1/8” clearance around the item is provided to avoid cracking due to
disparate expansion and contraction rates or stress transfer.
GROUTING
Non-sanded grout that is latex or polymer modified and compliant with A118.4 should be
used for our glass material. If sanded grout must be used for technical or aesthetic reasons,
gentle application of grout with a soft rubber float is recommended to minimize the
possibility of surface scratching. A “mock up” or testing installation should be executed to
ensure results are acceptable.
After grouting, wipe of excess surface grout with a slightly damp sponge - do not over wash.
After initial wash has been allowed to haze, wipe once with minimal pressure at a 45-degree
angel to joints and rinse sponge after wiping once with each side. Any remaining haze can
be buffed off with a dry towel or cheesecloth after grout surface has dried sufficiently.
CARE AND MAINTENANCE
For normal care and maintenance of glass tile, wiping the surface with a damp sponge or
clothe with water or a light vinegar solution is sufficient. If stronger cleaning is needed, a
nonabrasive, neutral pH cleaner can be used.
Glass tile may be damaged from impact with hard or heavy objects, which can lead to
chipping or breakage causing sharp cutting edges that can lead to injuries. Always replace
any damaged glass tiles immediately.