6” COBALT” SPORTCRAFT billiard table with cue rack/table dartboard with scoreboard tennis conversion top/ www.sportcraft.com TO ORDER PARTS, visit our website. MODEL#: 32942 PL (no.
INSPECT YOUR PLAYEIELD BEFORE ASSEMBLY! Your playfield/main table frame is NOT replaceable and the product will need to be returned to the original place of purchase if damaged. Please make sure to check it before beginning assembly. * Please make sure you received 1 box(es). UINSPECCIONE SU SUPERFIECE DE JUGAR ANTES DE ASAMBLEA! INSPECTEZ VOTRE L’AIRE DE JEU AVANT LTASSEMBLEE! «Su campo de juego/marco de mesa NO es reemplazable e el producto deberia ser devuelto a la tienda de ser dafiada.
Francais IMPORTANT! jIMPORTANTE! PLEASE KEEP YOUR INSTRUCTIONS AND RECEIPT/PROOF-OF -PURCHASE! e Please review the replacement parts guide and make sure that you have all your parts before beginning assembly. e For questions that may arise or for missing/damaged parts, PLEASE CONTACT US AT 4-800-526-0244 BEFORE RETURNING THE GAME TO THE STORE. e Please keep your Proof-of-Purchase (or Store Receipt) with your manual.
Do Not Use or Keep Product Outdoors. For Indoor Use Only. No Wet/Humid Conditions. A WARNING! A A jADVERTENCIA! Esto no es un juguete de nifios. La asamblea adulta es requerida antes del empleo. La supervisién adulta es requerida cuando los nifios juegan este juego. Por favor leer las instrucciones con cuidado. El empleo apropiado de este juego puede evitar el dafio o la herida. This is not a child’s toy. Adult supervision is required for children playing this game.
TOOLS REQUIRED HERRAMIENTAS NECESARIAS/ OUTILS NECESSAIRES Do Not Use Drill No use el taladro Ne pas utiliser de perceuse Philljos Head Screwdriver (not included) Destornillador Phillips (no incluido) Tournevis Philips (non inclus) Allen Wrench (included) Lilave hexagonal (incluida) Clé hexagonale (incluse) PARTS GUIDE GUIA DE PIEZAS / GUIDE DES PIECES For replacement, missing or defective parts.
REPLACEMENT PARTS: PIEZAS / | www.sportcraft.com DE RECAMBIO / PIECES Shaded box = pre-installed part (Caja coloreada = pieza preinstalada / Boite colorée = piéce préinstallée) (5) aaa (6) SILVER (X 4) (7) oO BOARD (X 4) (8) oO " (X 2) LEG - SUPPORT 32942PL05 APRON END oO DE RECHANGE 32942PL06 APRON SIDE o o o 9° 32942PL07 o o ; (X 2) 32942PL08 (X 4) (X4) | LEG CONNECTION BLOCK (X 8) (X 4) 32942PL14 (Siga a la pagina siguiente.
REPLACEMENT PARTS: WWW.SDO rtcraft.
REPLACEMENT PARTS: WWW.S portc raft.
REPLACEMENT PARTS: WWW.SDO rtcraft.
Strong Adults Needed: 4 No Children in Assembly Area No Pets in Assembly Area Adultos fuertes necesarios Ningunos nifios en el area de asamblea Ningunas mascotas en el area de asamblea Adultes forts nécessités Tenir les enfants loin du lieu d’assemblage Tenir les animaux domestiques English recommend that 4 adults work INSTRUCCIONES table will be assembled upside and then turned over onto its legs. is a very heavy table and turning it will require 4 strong adults.
STEP 2: Attach one Leg Support (#6) to one Leg - C (#4) using two Wing Nut Bolts (#450) and two Washers (#51). * Repeat the same for the other Legs - C. RED LABEL STEP 3: « Insert two Dowels (#46) into the Legs - A (#2) and - B (#8). e« Repeat the same for the other Legs - A and B. (DEE =) (B)&== = (4) 46 a= 32942 PL =(8) (Continued on the next page.) . 10 ©2010 Sportcraft, Lid. www.Sportcraft.
English STEP 4: Attach one Leg - C assembly (#4) to the one Leg - A and B assembly using two Wing Nut Bolts (#50) and two Washers (#51). « Attach one Leg Base (#5) to the bottom leg assembly using four Screws (#49).See Fig.4A. « Attach one L Shape Bracket (#60) to the top leg assembly using two Screws (#56).See Fig.4B. « Repeat the same for the other Leg assemblies. PF o AT @@ OSGeo « 32942 PL (Continued on the next page.) P. 11 ©2010 Sportcraft, Lid. www.Sporteraft.
STEP 5: Attach End Apron (#7) and Side Apron (#8) with Connection Blocks (#14) to between two Legs assembly using eight Bolts (#54) per Leg.See Fig.5A. Repeat above steps for the 32942 PL other End Apron (#7). (Continued on the next page.) P.12 ©2010 Sportcraft, Lid. www.Sporteraft.
STEP 6: « Using at least three strong adults, reach into the corner pockets to grasp the playfield. Slowly rotate the table over and place onto the leg assembly. PLEASE NOTE: Make sure you reach into the pockets to grab the billiard playfield. Then pick up the table. DO NOT lift the table by the pockets. « Place the table (#1) onto the leg assembly. e« From underneath the table, attach the table to the Side Aprons (#8) and End Aprons (#7) using eighteen eighteen Washers (#51) . See fig. 6B.
STEP 7: From underneath the table, attach the table to the legs using four Bolts (459) and four Washers (#53) per leg. See fig. 7A. 32942 PL (Continued on the next page.) P. 14 ©2010 Sportcraft, Lid. www.Sporteraft.
STEP 8: e Place the Table Tennis Surfaces - A (#20) and B (#19) face down on a clean, flat area. « Place four Wood Dowels (#48) into the openings on each side of Surface - B (#19). See Figures 8 and 8A. « If not already pre-installed, attach the Cushion Protectors (#47) to Surface - A #20). See Fig. 8B. mm.” ERY o—M-: [= o ee 32942 PL (Continued on the next page.) ZB P.15 ©2010 Sportcraft, Lid. www.Sporteraft.
STEP 9: « Assemble the Net (#38) and Posts (#36) per the illustrations. A) Place the Net Post Set (#38) on the sides of the Table Tennis Surface - B (#19). B) Gently pull up on the post and tilt outward. C) Tie the thread of the net onto the small hook and let ithang at the side of the net. Insert the small hooking rod into the sleeve of the net. D) Place the hooking rod into the top hole at the inside of the post. E) Tilt the post inward.
C1) eEEEEy = (1) 22) CEE = (1) 5) Cama = (2 6) pa = (4) WALL «xD STEP 10: ¢« Determine the desired rack location. Measure 20 inches up from floor. Insert Anchors (#57) into the wall at the required width for Cue Rack B (#22). e« Align Cue Rack B (#22) over the inserted Anchors attach to wall using two screws (#55). e Measure 54 inches up from the top of Cue Rack repeat first two steps to mount Cue Rack A (#21). 32942 PL (Continued on the next page.) (#57) and B (#22) and P.
STEP 11: ¢« Attach Dartboard Support Board (#24) to the bottom underside of the Cabinet (#23) using two Screws (#56). of the STEP 12: « Attach Cabinet assembly and Scorer Board (#26) onto the Wall using two Screws (#55) and two Dowels (#57) per Cabinet and Scorer Board. NOTE: Correct height for the dartboard is 68 inches from the center of the bullseye to the floor. Adjust the hanging height of the cabinet to achieve the desired dartboard height. Hanging the Dart board (#25) to the frame.
TABLE MAINTENANCE (MANTENIMIENTO DE LA MESA) Keep your table covered. If there is dust on the playfield or the aprons, use a vacuum or use the brush provided to remove. table and do not use the table outside. hee Table Do not sit on the Cubra su mesa. Si hay el polvo. sobre.el campo de juego o los guarniciones, use un vacio.o el cepillo proviso para quitarlo. No siéntese sobre la mesa y no utilice la mesa afuera. Tenez votre. table couverte. S'il y.a dela poussiére sur laire de jeu ou.:.
BILLIARD RULES -8 BALL OBJECT OF THE GAME: 8 Ballis a simple game enjoyed by players of all skill levels. Itis a Called Shot Game, meaning that players must announce their intended shot in advance in order for it to count. In 8 Ball, one player shoots at solid balls (numbers 1 though 7), while the opponent shoots at striped balls (numbers 9 through 15). The player who pockets his or her ball group first and then sinks the 8 ball is the winner. THE BREAK: The bails are racked as shown in the illustration.
SPOTTING BALLS: Whenever an object is to be spotted, the object ball is spotted on the long string as close to the foot spot as possible. LOSS OF GAME: A 1. 2. 3. 4. 5. 6. player committing any of the following infractions loses the game: Fouls when pocketing the 8 ball. Pockets the 8 ball on the same stroke as the last of his group of balls. Scratches when the 8 bail is his legal object bail. Jumps the 8 ball off the table at any time. Pockets the 8 ball in a pocket other than the one designated.
3. A scratch shot (shooting the cue ball into a pocket or off the table) 4. Moving or touching any ball by means other than legal play. 5. When the object ball is not pocketed, failure to drive the any ball after the cue ball has made contact with the object ball. 6. Shooting an intentional jump shot over another ball by scooping stick under the cue ball. A jump shot executed by striking the above center is legal. 7. Driving any bail off of the table. The object balls are not re-spotted the 9 Ball).
-- it has been volleyed. -- it touches a player, or anything he wears or carries, other than his racket or his racket hand below his wrist. -- it touches any object other than the net or its support (referred to above). -- itis struck by a player more than once consecutively. -- it touches, in a doubles service, the left half-court of the server or receiver. -- itis struck, in doubles, by a player out of sequence, except where there has been a genuine error in playing order.
services and are received by the partner of the first server. -- the third five services are delivered by the partner of the first server and are received by the partner of the first receiver. -- the fourth five services are delivered by the partner of the first receiver and are received by the first server. -- the fifth five services are delivered and received as the first five, and so on until the end of the game, or the score 20-20.
ROUND THE CLOCK: |n this game, the player tries to hit the numbers from 1 to 20 in order. When a number is hit, then the game is advanced for shooting the next number. The player who reaches and hits 20 first is the winner. Doubles and triples are treated the same as a single, being counted as one hit. ALL FIVES: The total score for each throw of 3 darts must be divisible by 5, each multiple of 5 scores 1 point. Each dart in a throw must score.
Budd Lake, NJ 07828 —_ 32942 PL Wwwsporteraft.com Printed in China / Impreso en China / imprimé en Chine ©2010 Sporteraft, Ltd. www.Sporteraft.
