Installation Guide

8 1-800-732-0144

PREPARE THE COLLAR RECEIVER

CHARGE THE COLLAR RECEIVER

1. Lift the rubber cover protecting the

Charging Jack.

2. Connect one of the charger connectors

to the Charging Jack.

3. Plug the charger into a standard

120-volt AC wall outlet.

4. Charge the Collar Receiver for 24 hours

for the ﬁ rst charge. Recharges take only

12 hours. NOTE: The Receiver Indicator

Light will ﬂ ash after 12 hours of

charging. For the ﬁ rst charge, continue

to charge the Collar Receiver for an

additional 12 hours.

5. When charging is complete, replace the

rubber cover.

If the Collar Receiver is used in or around salt water, the Collar Receiver should be rinsed with fresh

water following each use. Prior to rinsing, the rubber charging jack cover should be removed from the

power plug socket and left out until the Collar Receiver has air dried.

TO TURN THE COLLAR RECEIVER ON

1. Momentarily press and hold the On/

Oﬀ Button until the Receiver Indicator

Light comes on and the Collar Receiver

beeps 5 times.

2. Release the On/Oﬀ Button.

The Receiver Indicator Light will ﬂ ash

until the Collar Receiver is turned oﬀ . The

ﬂ ashing light indicates the Collar Receiver

is ready to receive a radio signal from the

Remote Transmitter.

TO TURN THE COLLAR RECEIVER OFF

1. Momentarily press and hold the On/Oﬀ Button until the Receiver Indicator Light comes on solid and

the Collar Receiver beeps 2 times.

2. Release the On/Oﬀ Button.

To extend the life between charging cycles, turn the Collar Receiver oﬀ when it is not in use.

NOTE: Approximate battery life between charges is 40 hours, depending on frequency of use.

STEP :: 02

CHARGER CONNECTOR

PLACED IN COLLAR

RECEIVER CHARGING JACK

ON/OFF BUTTON