user manual

6300/6310 Treadmill Electronics Repair Manual – Drive
6300/6310 Drive Board LEDS – Normally Lit
DRIVE.03
LED10 “CLK” LED
ÎLights to indicate
reception of optic sensor
signal.
LED3 Incline “DOWN” LED
ÎLights when incline DOWN is
pressed. Indicates power to incline.
LED4 Incline “UP” LED
ÎLights when incline UP is pressed.
Indicates power to incline.
LED1 “ON” LED
ÎLights when power switch is
turned on. Extinguishes when
emergency knob is activated or
unit is off.
LED6 “SOFT” Circuit LED
ÎLights two seconds after
unit power comes on.
Extinguishes when
emergency knob is
pressed or unit is turned
off.
LED2 “VCC” Circuit LED
ÎLights when power
switch is on. Indicates
VCC (display) circuit
power.
LED9 “Belt Pull” LED
ÎLights normally. Extinguishes if
belt if pulled faster than speed
setting.