Use and Care Manual

!
GPDR!!!!!2'Cycle!Pile!Driver!Instruction!Manual!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!15!
!
EMISSION!CONTROL!SYSTEM!!WARRA NTY!!!!BUFFALO!CORPORATION!
Your Warranty Rights and Obligations
The California Air Recourse Board, U.S. EPA and Buffalo Corp. are pleased to explain the Emission Control System
Warranty on your 2019 model year new outdoor power equipment engine.
California!
In California, new spark-ignited small off-road equipment engines must be designed, built and equipped to meet the State’s
stringent anti-smog standards.
Other States, U.S. Territories
In other areas of the United States, your engine must be designed, built and equipped to meet the U.S. EPA emission
standards for spark-ignited engines at or below 19 kilowatts.
All!of!the!United!States!
Buffalo Corp. must warrant the emission control system on your power equipment engine for the periods of time listed below
provided there has been no abuse, neglect or improper maintenance of your power equipment engine. Where a warrantable
condition exists, Buffalo Corp. will repair your power equipment engine at no cost to you including diagnosis, parts and
labor.
Your emissions control system may include parts such as: carburetors or fuel injection system, ignition system, catalytic
converters, fuel tanks, valves, filters, clamps, connectors, and other associated components. Also, included may be hoses,
belts, connectors, sensors, and other emission-related assemblies.
Manufacturer’s Warranty Coverage:
The emission control system is warranted for two years. If any emissions-related part on your engine is defective, the part
will be repaired or replaced by Buffalo Corp.
Owner’s Warranty Responsibility
As the power equipment engine owner, you are responsible for the performance of the required maintenance listed in your
owner’s manual. BUFFALO CORP. recommends that you retain all receipts covering maintenance on your power
equipment engine, but BUFFALO CORP. cannot deny warranty solely for the lack of receipts or for your failure to ensure the
performance of all scheduled maintenance.
As the power equipment engine owner, you should however be aware that BUFFALO CORP. may deny your warranty
coverage if your power equipment engine or a part has failed due to abuse, neglect, improper maintenance or unapproved
modifications.
You are responsible for presenting your power equipment engine to distribution center or service center authorized by
BUFFALO CORP. as soon as the problem exists. The warranty repairs should be completed in a reasonable amount of
time, not to exceed 30 day.
If you have any questions regarding your warranty rights and responsibilities, you should contact Buffalo Corp. customer
service representative at 1-866-460-9436 or write to info@buffalotools.com
DEFECTS WARRANTY COVERAGE
Adopted by the Air Resources Board, Buffalo Corp. warrants to the ultimate purchaser and each subsequent purchaser that
the small off-road engine (SORE)(1) has been designed, built and equipped so as to conform with all applicable regulations;
and (2) is free from defects in materials and workmanship that cause the failure of a warranted part to conform with those
regulations as may be applicable to the terms and conditions stated below.
The warranty period begins on the date the engine is delivered to an ultimate purchaser or first placed into service. The
warranty period is two years.
Subject to certain conditions and exclusions as stated below, the warranty on emissions related parts is as follows:
Any warranted part that is not scheduled for replacement as required maintenance in your Owner’s Manual is warranted for
the warranty period stated above. If the part fails during the period of warranty coverage, the part will be repaired or
replaced by Buffalo Corp. According to Subsection (4) below. Any such part repaired or replaced under warranty will be
warranted for the remainder of the periods.
Any warranted part that is scheduled only for regular inspection in your owner’s manual is warranted for the warranty period
stated above. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.
Any warranted part that is scheduled for replacement as required maintenance in your owner’s manual is warranted for the
period of time before the first scheduled replacement date for that part. If the part fails before the first scheduled
replacement, the part will be repaired or replaced by Buffalo Corp. According to Subsection (4) below. Any such part
repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled
replacement point for the part.