Replacement Part List

6
!
6.
Unscrew gas cap slowly to vent, add the remainder of fuel requirements
7. Wipe away any spilled fuel or oil and allow to evaporate before moving or transporting.
STARTING
Before starting the new machine, press the transparent and semi-circle fuel bubble repeatedly
(Fig.12) until Carburetor is filled with fuel. (If the engine is cool, close the air door. Open air door
after starting.)
Fig.12
Set the machine upright according to Fig.12. Hold the upper part of handle tightly with one hand
while the other pulls the pulling handle of starter for over 20 inches quickly. Do not let the recoil
handle go back freely in repeated pulling. Instead, hold it tightly to avoid injury.
Start the engine and then open air door completely. After idle operation of 5 minutes, start normal
work.
OPERATION
6.1 After engine is started, first carry out idle operation of 5 minutes to warm up the machine.
When the engine is warmed up, press throttle handle to the appropriate regulatory position
according to the required impact energy.
Note: The gasoline pile driver use shall mainly boast low or medium-speed for work in the first 24
hours of operation and the maximum throttle shall not be used in order to extend the service life.
6.3. Operating speed of gasoline engine shall be low or medium speed.
6.4. High-speed operation of pile driver during non-piling is prohibited.
Start Button
OFF
and
of
cold engine)
Fuel Bubble