Instructions / Assembly

ITEM # GUCMBLS UTILITY CEILING BIKE LIFT

ASSEMBLY INSTRUCTIONS

DO NOT OVERLOAD! Max Weight Capacity is 44 lbs.

WARNING

IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR

UNSAFE, DO NOT USE THIS PRODUCT!

If you experience a problem, have questions or need parts for this product,

call Customer Service at 1-636-532-9888, Monday - Friday, 8 AM - 4 PM

Central Time. A copy of the sales receipt is required. KEEP THIS MANUAL,

SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE

REFERENCE.

WARNING

Do not support any item other than the intended product use. This is not a toy -

keep out of reach of children. Serious injury can occur if this item is misused.

Excessive weight will cause the pulley to grind, become hard to operate, and

may fray the rope, leading to possibe failure. When calculating the weight of the

bike, include all bags and accessories that might be attached when lifted.

Thread the nylon rope through the pulley system before mounting to ceiling. Start

by threading the rope through the clutch brake device as shown. Follow the thread

route (A - F). Be sure the hooks at (B) and (E) face inward. Thread the end of the

rope through the center hole in the bracket (F). Tie a double knot to secure the end.

ATTENTION

PAGE 1
ITEM # GUCMBLS UTILITY CEILING BIKE LIFT ASSEMBLY INSTRUCTIONS C A D F E B ATTENTION Thread the nylon rope through the pulley system before mounting to ceiling. Start by threading the rope through the clutch brake device as shown. Follow the thread route (A - F). Be sure the hooks at (B) and (E) face inward. Thread the end of the rope through the center hole in the bracket (F). Tie a double knot to secure the end. WARNING DO NOT OVERLOAD! Max Weight Capacity is 44 lbs.
PAGE 2
ATTENTION This unit is designed to hold ONE bike only. Check that the handle bar and seat are securely attached to bike. Do not install near electrical outlets, or where human traffic may occur. TOOLS REQUIRED 8'-10' ladder Drill with 3/16" drill bit Tape measure Stud finder Pencil Wood screws (included) ASSEMBLY 1) A solid 2" x 4" or larger wood ceiling joist is required to mount your Bicycle hoist. 2) Determine that you have sufficient clearance.
PAGE 3
PAGE 4