Instructions / Assembly

Hex Wrench
16 Hex Set Screws
SSWTABLE, SSWTABLE36, SSWTABLE60, SSWTABLE72
Stainless Steel Work Table
Assembly Instructions
Locate the accessory bag and remove
the 16 hex set screws and 1 hex
wrench. Locate 4 table legs, one table
top and one table base.
Place table top upside down on soft
cloth surface to prevent scratches.
Insert one leg into a corner support.
Table
Top
Using the hex wrench, loosely tighten
the hex set screws (with the HEX side
visible) into the corner support.
Each corner support requires two
hex set screws. Wait until the table is
completely assembled before securely
tightening each hex set screw.
Each corner support requires two
hex set screws. Wait until the table is
completely assembled before
securely tightening each Hex screw.
All four legs can be adjusted for
surfaces that aren’t completely level.
Rotate the plastic foot pad to compensate
for differences in floor surface.
Turn the table over AFTER
securely tightening each hex set
screw. Two people may be
required to rotate the table.
Contact: [e-mail] http://www.sportsmanseriesbrand.com 636-532-9888
1 2 3
4
7 8 9
After three legs have been loosely
attached, lower the adjustable table
base and insert each leg through the
base holes. Then fix the table base
on the marked label position.
Slide the last leg.
5 6
Adjustable Table
Base