Installation Instructions

NOTE:

1. Do not over-tighten the nuts and bolts at every step.

2. Do not snap in the cover of plastic cap until you have finished the assembly of

each step and went back to tighten all of the nuts and bolts.

STEP 5

 Attach R8 and R3 to A1.

 Secure using F2, F3 and F1-1.

STEP 6

 Insert the bolt of R2B (which is pre-assembled with R1) into holes of R4.

 Secure using F4 and F3.

 Assemble the remaining three R2B chains to R4 in the same way.

 See figure below.

F1-1

R2B