User Manual

Items needed
The prepared engine from previous step
The assembled buggy
Four 5x8mm Engine Mounting Screws
(SWK2074)
Tuned Pipe Mounting Wire (SWK3238)
Tuned Pipe Mount (SWK3240)
Exhaust system (not included)
4x4mm Set Screw (SWK2440)
4x8mm Flathead Screw (SWK2054)
Air Filter (SWK3232)
Air filter oil (not included)
Fuel tubing (not included)
Step #1
Using the four 5x8mm engine mounting screws,
mount the engine to the chassis, tightening
lightly.
Step #2
Adjust the gear mesh such that the clutch
bell has only a slight amount of backlash
then securely tighten the engine mounting
screws. Recheck for proper gear mesh and
adjust as necessary.
Note: The gears should freely spin with
minimal noise and only a slight amount of
backlash (gear free play).
Page 10
Engine and Exhaust System Installation