User Manual

Step #3
Assemble and install the tuned pipe mount and
mounting wire on the chassis using the 4x4mm
set screw and the 4x8mm flathead screw. Don’t
tighten these screws at this time.
Step #4
Assemble the exhaust system (not included) and
trial fit it in place. Note that the mounting wire
should be adjusted to allow the pipe to naturally
align with the engine exhaust outlet. When you’re
satisfied with the position of the pipe mount and
mounting wire, securely tighten the screws.
Step #5
Secure the header to the engine using the spring
supplied with the exhaust system.
Note:On some exhaust systems, it may be
necessary to slightly trim the mudguard to
provide clearance for the exhaust.
Engine and Exhaust System
Page 11