User Manual

Step #1
Remove the three 3x10mm flathead screws on
the top of the radio tray and the four 3x10mm
flathead screws on the bottom of the chassis that
attach the radio box and remove the assembly
from the chassis.
Step #2
Install the grommets and eyelets included with
your radio system in both servos.
Step #3
Using the eight 3x10mm button-head screws
included in the kit, install the servos in the tray as
shown, noting the position of the output shafts.
Note: If using a personal transponder, install
it on the provided mount at this time.
Radio System Installation
Page 14