User Manual

Step #7
Secure the receiver in place as shown using
two layers of servo tape. Use two layers of
servo tape under the receiver to help isolate
it from vibration.
Step #8
Install the antenna tube and thread the antenna
through the tube, allowing several inches to
be exposed at the tip of the tube. Place the
antenna cap over the end of the antenna to
fasten it in place.
Note:A single drop of thin CA glue can be
used to secure the antenna tube to the radio
box, preventing the tube from falling out
during a crash.
Step #9
Hook up the servos, battery and switch per the
instructions included with the radio system and
charge the receiver pack.
Step #10
Reinstall the radio tray assembly in the buggy
using the same seven 3x10mm screws. Three
screws are used in the top to attach the radio
tray, and four from the bottom of the chassis to
attach the radio box.
Radio System Installation
Page 16