User's Manual

Initial System Setup/Test 14
KEY FOB SYSTEM SETUP
The Key FOB device system test is similar to the Keypad.
1. When batteries are inserted, the FOB performs a self test to check
battery level and presence of the Tracker.
2. If the FOB successfully establishes a connection to the Tracker, the
Tracker Range LED blinks green for 1 minute.
3. If the Tracker is not present the FOB Tracker Range LED blinks
red every 3 seconds for 1 minute. You must move closer to the Tracker
unit to establish a connection.
If the FOB is lost/stolen or you will need to deactivate the remaining FOBs
for security reasons. Perform the following steps:
1. Bring remaining FOBs into range of the Tracker (within 60 ft).
2. Change PIN on Keypad. This will deactivate the lost/stolen FOB and
reset the pairing on the remaining FOB.
3. If all FOBs are lost/stolen, enter PIN on Keypad and turn off “arm”
state OR remove power from Tracker.
4. Order replacement FOBs from findmeSPOT.com
SEND A TEST CHECK-IN/OK MESSAGE
SPOT HUG recommends testing the Check-in/OK during the initial
system set-up, on occasion and before every trip to ensure messages
are sent and delivered properly. Before sending your first Check-in/OK
message, synchronization of the Keypad and Key FOB devices with
the Tracker are required. Follow directions in the FOB and Keypad System
Test sections.
For first time set-up, the Test Check-in/OK Message is to be completed
after passing the self-test.
1. For the initial Test Message, ensure the Tracker unit has a clear view of
the sky and with the arrow logo pointing upward.
2. To send a message, press the Check-in/OK button on the FOB
or the Keypad. The GPS indicator LED on the FOB and Keypad blink
green as the Tracker acquires a GPS fix.
3. Once the Tracker acquires your GPS location, the Message Sending
LED and GPS LED on the Keypad will blink green in unison for ~15
seconds to notify you that your message is being transmitted with GPS
location. The GPS LED on the FOB will blink green for 15 seconds.
The Message Sending LED on the Keypad will continue to blink green
over the remainder of the 20-minute message cycle and for one (1)
hour after the end of the message cycle. The Check-in/OK function LED
will turn off once the message cycle is complete.
4. If the GPS LED blinks red, the Tracker does not have a clear view of the
GPS satellites and you must move to an area with a clearer view of the
sky for proper operation. Once you move to an area with clearer view of
the sky, repeat steps 1 through 4.
5. Verify that the message was received in the email or SMS account(s)
that were set up during activation in your Check-in/OK contact list.
You can also view your messages in your account at findmeSPOT.com.
SPOT HUG USER MANUAL