User's Manual

Installation 17
INSTALLATION OF KEYPAD
The Keypad is the device required to activate the Key FOB during the
initial setup phase. For security, the user is required to change the
factory default PIN before use (A step covered previously in the Keypad
System/Test section).
1. Locate a place where the Keypad can be mounted inside the cabin.
The Keypad needs to be within 60 feet/18 meters of the Tracker.
Tracker Range can be checked with a quick press of the Check-in/OK
button on the Keypad. If the Tracker Range LED blinks green the
Keypad is within range of the Tracker. It is recommended the Keypad
unit be placed in a sheltered environment from weather elements or
extreme temperatures.
2. Remove the Keypad mounting bracket and mark the four holes with
a pencil before drilling the holes into the surface. Carefully align the
mounting plate where the holes are marked and use a screwdriver to
fasten the four screws onto the surface.
3. If using double-sided adhesive mounting tape, remove the double
adhesive protective paper and place the adhesive pad in the center of
the back mounting plate. Clean the surface of the area where the
Keypad is going to be mounted. Firmly press the Keypad mounting
bracket with the adhesive pad to the area.
4. After the Keypad mounting bracket is secured in place, attach the
Keypad by sliding the back into the cleat of the mounting bracket.
‡
SPOT HUG USER MANUAL