User's Manual

Keypad Functions 26
SPOT HUG USER MANUAL
The Keypad can be used to manually arm/disarm SPOT HUG. It is also
used to turn on/off the GPS information in the daily status message,
change PIN, pair additional Key FOBs and to enable/disable sensor alerts.
Finally it can also be used to initiate and cancel SPOT modes.
• Press and release button unless specied otherwise
• After pressing Check-in/Ok, audio and visual feedback conrms
successful or unsuccessful entries
AUDIO FEEDBACK
• Successful – solid beep; Unsuccessful – 3 beeps
VISUAL FEEDBACK
• Successful – single green blink on Check-in/OK LED;
Unsuccessful – 3 green blinks on Check-in/OK LED
Enter PIN press Check-in/OK
Enter PIN press Check-in/OK
Enter PIN press Check-in/OK
Enter PIN press Check-in/OK
1. Enter PIN (or enter default PIN, which is the last 4 digits of Authorization code, for initial
setup only)
2. Press Check-in/OK
3. Enter new PIN followed by Check-in/OK
4. Enter new PIN again followed by Check-in/OK
5. Quick Press Check-in/OK on each FOB
1. Enter PIN
2. Press Check-in/OK
3. One FOB at a time, press Check-in/OK and Track Buttons on Fob simultaneously for 3 seconds
4. Repeat #7 & 8 for all FOBs within 5 minutes.
1. Enter Default PIN followed by Check-in/OK
2. Enter existing PIN followed by Check-in/OK
3. Enter 8 digit ESN (excluding the dash) followed by Check-in/OK
Theft Recovery Mode Off
Theft Recovery Mode On
Daily Status Off
Daily Status On
PIN Change (or setup)
Pair FOBs
Pair Keypad with Tracker
00
01
02
03
04
05
06
KEY PAD FUNCTION
ENTER NUMBERS
ADDITIONAL DIRECTIONS
PRESS CHECK-IN/OK
+
+
+
+
+
+
+
+
+
+
+
+
+
+
1. Enter PIN
2. Press Check-in/OK
3. Press the number (1-4, 9 for all) of the contact to be enabled
4. Press Check-in/OK
1. Enter PIN
2. Press Check-in/OK
3. Press the number (1-4, 9 for all) of the contact to be disabled
4. Press Check-in/OK
1. Enter Last 4 digits of Authorization code
2. Press Check-in/OK
3. Enter new PIN followed by Check-in/OK
4. Enter new PIN again followed by Check-in/OK
5. Quick press Check-in/OK on each FOB
1. Press (1 = low, 2 = medium, 3 = high)
Low setting is recommended for boats less than 30 ft.
2. Press Check-in/OK
1. Enter PIN
2. Press Check-in/OK
Sensor Alert Enable
1: #1
2: #2
3: #3
4: #4
9: All
Sensor Alert Disable
1: #1
2: #2
3: #3
4: #4
9: All
PIN Reset
Vibration Sensitivity Setting
Cancel SPOT Modes Activated
on FOB
07
08
09
12
19
+
+
+
+
+
+
+
+
+
+