User's Guide

4 5

WHAT YOU NEED

• Your SPOT Gen3

• One of these three power sources:

- 4 AAA Energizer

Ultimate Lithium 8x batteries (L92); included

- 4 AAA Energizer

NiMH rechargeable batteries (NH12)

- Line Power with a 5v USB connection

• User Guide

INSTALL THE INCLUDED BATTERIES

1. Loosen the screws to open the battery cover.

2. Write down the ESN and Authorization Code for use during service activation.

3. Install 4 AAA Energizer

Ultimate Lithium 8x batteries or NiMH rechargeable batteries.

4. Replace cover, tighten screws with a screwdriver or coin. It is important that you

fully tighten the battery cover to maintain SPOT's waterproof seal.

WHAT YOU NEED

• Personal contact information

• Emergency contact information

• Valid email address

• Credit card information

• SPOT electronic serial number (ESN) and authorization code.

ACCOUNT SETUP

1. Go to FindMeSPOT.com/Activate.

2. Existing SPOT customers should login to their current SPOT account to add their new device. New

customers will need to select: Set Up New Account.

3. Follow the instructions given within the activation portal; do not skip forms or pages.

4. Choose the services you wish to add (like the new upgraded Unlimited and Extreme Tracking) to

your SPOT device and conﬁrm your order to ﬁnish the activation process.

Your SPOT Gen3 requires an active SPOT subscription to communicate. To do this,

simply activate your device using the instructions outlined below.

SecTiOn 2: GeTTinG STaRTed

WITH YOUR SPOT

AT FINDMESPOT.COM

ESN: 0-0000000

Auth: 00000000

These codes are located inside the battery compartment

of your SPOT Gen3. You will need these codes when

setting up your account on FindMeSPOT.com/Activate.

SERIAL NUMBER (ESN) AND

AUTHORIZATION CODE

ELECTRONIC SERIAL

NUMBER (ESN)

AUTHORIZATION CODE