Product Info

GLOBALSTAR PROPRIETARY AND CONFIDENTIAL INFORMATION
Use or disclosure of data contained on this sheet is subject to the restrictions in the Distribution Statements on the title page of this
document.
06/18/20 Subject to Change without Notice P a g e | 78
5.2.2 Step 2: Set the channel that you wish to perform the test on.
Use the “setup” command for this. Using the configuration application in “advanced” mode:
• Tap the “auth” button.
• Send the command: “setup <ch> 3 60 120”
• Where “<ch> =
o 0 = Channel A
o 1 = Channel B
o 2 = Channel C
o 3 = Channel D
5.2.3 Step 3: Start the desired mode.
Using the configuration application in “advanced” mode:
Tap the “auth” button.
• For CW Mode, send the command: “raw aa06fc01”
• For Mod Mode, send the command: “raw aa06fc03”
• To send a single test packet, send the command: “raw aa06fc02”
• When entering each of the commands above, you should see an ACK: “aa05fc” and 2 bytes of CRC
Repeat steps 2 and 3 for the tests you want to perform on each channel.
5.2.4 Step 4: Disable the test commands.
After turning the power off following the last test, use the configuration application in “advanced” mode to do the
following:
• Tap the “auth” button
• Send the command: “raw aa067600”
• Watch for the ACK, which should be “aa0576” and 2 bytes of CRC
5.2.5 Step 5: Restore the desired setup.
• Tap the “auth” button.
• Send the command: “setup <ch> <transmit attempts> <min time between attempts> <max time between
attempts>”
• Note: Factory default settings are: “setup 0 3 60 120”