User's Manual

Revision 0.2 STINGR Users Manual
06/24/15 Revision 0.2 Subject To Change without Notice P a g e | 27
5.2.4 STINGR Serial Test Commands
5.3 “Transmitter Test” command
This command is used to initiate a transmitter test in one of three modes.
Transmitter test command format
Byte
Bit
s
Parameter
Description
0 0 - 7 Leader
Always a value of 0xAA.
1 0 - 7 Length
0x06
2 0 - 7 Command Code.
0xFC = Transmitter test.
3 0 - 7 Test mode
The following test modes may be selected:
0x01 = CW Mode
0x02 = Transmit single test packet.
0x03 = Mod mode. Transmit a continuous
signal modulated with a bit pattern.
4 – 5 0 - 15 CRC
Leader Len Cmd
Test
Mode CRC1 CRC2
AA 06 FC
02
2E A2
Example Command: AA 06 FC 02 2E A2
Where:
• Test Mode: 0x02 = Single Test Packet