User's Manual

I
NSTALLATION
12
SpotCell 100, Release 1.0
If mounted on a ceiling, the unit should be downward facing, and in the
center of the area requiring cell phone coverage.
If mounted on a wall, the unit should be positioned in the middle of the
area to be covered side-to-side, and off-centered slightly front-to-back,
approximately as shown below in Figure 3.4:“CU position and signal
coverage.”. The unit should be mounted as high on the wall as possible.
Figure 3.4: CU position and signal coverage.
3.3.1 Positioning the CU
1.
Ensure that the DU position has been optimized and has been
mounted in place.
2.
Move the switch on the CU from ‘Install’ to ‘Active’.
3.
Hold the CU in the position it is to be mounted. In an ideal
application, the display on the CU will show 5 bars. If the display is
not showing 5 bars and there are alternate possible mounting
locations, move the CU to the alternate locations and check the
display. Place the CU in the location showing maximum number
of bars (see Figure 3.5:“Displayed Signal Strength”). In the event the
number of bars is not changing, which is very possible, choose a
location that is most convenient.