User's Manual

Spotwave Wireless Inc. 13
4 – Mounting the DU and CU
4.1 Running Cable Through Walls
If it is necessary to run a cable through a wall, use a masonry or wood drill bit to drill a
3/4-inch diameter hole.
After passing the cable through, use the putty in the installation kit to fill the hole around
the cable.
4.2 Mounting the DU
The DU (or two DUs for dual band SC141/142 systems) may be indoor or outdoor
mounted. Based on the direction the DU will point, consider possible mounting
locations.
All necessary hardware required for mounting on internal or external walls, or on pipes is
included in the mounting kit.
The illustrations on the following pages show some of the possible mounting options.
4.2.1 Wall Mount
Figure 4.1: Wall Mount
The mounting shown in Figure 4.1: allows for no
significant left or right rotation, but provides a wide
range of down-tilt when the lower circular slot on the
angle backplate is used, a wide range of up-tilt when the
upper circular slot is used, but no up-tilt or down-tilt
when the center hole on the backplate is used (the
center hole is hidden from view in Figure 4.1:).
Lower circular slot
Upper circular slot