User's Manual

MOUNTING THE DU AND CU
14 SpotCell® 100 Series
4.2.2 Overhead Mount
Figure 4.2: Overhead Mount
The mounting shown in Figure 4.2: provides
left to right rotation, and a wide range of
down-tilt using the upper circular slot or a
small amount of up-tilt and down-tilt when the
bottom circular slot is used.
4.2.3 Horizontal Surface Mount
Figure 4.3: Horizontal Surface Mount
The mounting shown in Figure 4.3: allows for
left to right rotation and a wide range of
upward tilt using the lower circular slot, or a
small amount of down tilt and down tilt when
the upper circular slot is used.
4.2.4 Pipe Mount
Figure 4.4: Pipe Mount
Use hose clamps to mount the unit to a 2-in to
5-in pipe.
The mounting shown in Figure 4.4: allows for
complete left to right rotation with a limited
range of up-tilt or down-tilt.
If the hose clamp bracket is reversed to extend
down then the up-tilt range will increase if the
DU is mounted at the top of the pipe, but the
down-tilt range is unchanged.