User's Manual
Table Of Contents
- Technical Support
- Important Safety Information
- LIMITED WARRANTY AND LIMITATION OF LIABILITY:
- 1 - Introduction
- 2 - Getting Started
- 3 - Installation
- 4 - Mounting the DU and CU
- 5 - Display Information
- 6 - Trouble-Shooting
- Appendix A - SpotCell 100 System Specifications
- Appendix B - SpotCell 111/112 System Specifications
- Appendix C - SpotCell 163 System Specifications
- Appendix D - SpotCell 167 System Specifications
- Appendix E - SpotCell 141/142 System Specifications
- Appendix F - Safety Hints
Spotwave Wireless Inc. 41
Appendix D – SpotCell 167 System Specifications
Note: Spotwave Wireless has the right to change specifications without notice.
4.1 DU LED signal indications:
4.2 Antenna Specifications:
RED
(flashing)
BS signal too low, or too high. No acceptable signals at “preferred channel” fre-
quencies. Adjacent band power may also be too high.
YELLOW
(flashing)
BS signal is 5 dB or more below highest level but within operational range
GREEN
(flashing)
BS signal is locked onto an acceptable “preferred channel”
DU Antenna CU Antenna
Gain (dBi) 10 0 ± 3
Elevation Beamwidth - typical (dg) 62 115
Azimuth Beamwidth - typical (dg) 50 105
Front-to-Back Ratio (dB) 20 12
Polarization Vertical Horizontal & Vertical