User's Manual
Table Of Contents
- Technical Support
- Important Safety Information
- LIMITED WARRANTY AND LIMITATION OF LIABILITY:
- 1 - Introduction
- 2 - Getting Started
- 3 - Installation
- 4 - Mounting the DU and CU
- 5 - Display Information
- 6 - Trouble-Shooting
- Appendix A - SpotCell 100 System Specifications
- Appendix B - SpotCell 111/112 System Specifications
- Appendix C - SpotCell 163 System Specifications
- Appendix D - SpotCell 167 System Specifications
- Appendix E - SpotCell 141/142 System Specifications
- Appendix F - Safety Hints
SpotCell 167 43
4.3.2 Installation
4.3.3 Indicators & Diagnostics
4.3.4 Optional Coverage Extension Kit
Installation
Time
Less than one hour typical
Outdoor Unit
Alignment
No prior knowledge of base station location required.
Built in alignment algorithm (LED Indicator on DU).
Test Equipment None required.
No RF knowledge required for installation.
Easy to read LCD display and LED indicators guide the instal-
lation.
User Controls None, setup and operation is fully automatic.
Fault Indicators CU: LCD display and LED indicator
DU: LED used during installation only
Remote Connectivity Serial data port on indoor unit
System Interrogation LCD indicator on indoor unit
Coverage Area
Up to 6,000 ft
2
(550 m
2
)
Antenna 1900 MHz (passive with same specifications as CU
antenna)
Cables Standard: RG6 Quad shielded 82 ft (25 m) c/w F con-
nectors and MCX right angle adapter kit
Alternate: RG6 Plenum rated cable with above MCX
adapter kit