User's Guide
Table Of Contents
- 1 - Introduction
- 2 - Getting Started
- 3 - Mounting the DU
- 4 - Installation
- 5 - Display Information
- 6 - Trouble Shooting Information
- Appendix A - SpotCell 100 Series Specifications
- Appendix B - SpotCell 111 System Specifications
- Appendix C - SpotCell 112 System Specifications
- Appendix D - SpotCell 111s/112s System Specifications
- Appendix E - SpotCell 163 System Specifications
- Appendix F - SpotCell 141/142 System Specifications
- Appendix G - Safety Hints
INSTALLATION
22 SpotCell
Note: On the upper floors of tall buildings, it may be necessary to tilt
the DU down to get a good signal (green LED).
12. Proceed to page 7 for mounting instructions once the DU location
has been optimized.
4.3 Choosing a location for the SpotCell CU
The CU should be optimized and mounted, after the DU has been
optimized and mounted. Generally, the CU should be mounted in a
location as far as possible from the DU, while being within the area
where you require improved coverage.
If mounted on a ceiling, the unit should be downward facing, and in the
center of the area requiring cell phone coverage.
If mounted on a wall, the unit should be positioned in the middle of the
area to be covered side-to-side, and off-centered slightly front-to-back,
approximately as shown below in Figure 4.4:“CU position and signal
coverage”. The unit should be mounted as high on the wall as possible.
Figure 4.4: CU position and signal coverage