User's Guide
Table Of Contents
- 1 - Introduction
- 2 - Getting Started
- 3 - Mounting the DU
- 4 - Installation
- 5 - Display Information
- 6 - Trouble Shooting Information
- Appendix A - SpotCell 100 Series Specifications
- Appendix B - SpotCell 111 System Specifications
- Appendix C - SpotCell 112 System Specifications
- Appendix D - SpotCell 111s/112s System Specifications
- Appendix E - SpotCell 163 System Specifications
- Appendix F - SpotCell 141/142 System Specifications
- Appendix G - Safety Hints
Spotwave Wireless Inc. 23
4.3.1 Positioning the CU
1. Ensure that the DU position has been optimized and has been
mounted in place.
2. Move the switch on the CU from ‘Install’ to ‘Active’.
3. Hold the CU in the position it is to be mounted. In an ideal
application, the display on the CU will show 5 bars of signal
strength and coverage area. If the display is not showing 5 bars for
coverage area and there are alternate possible mounting locations,
move the CU to the alternate locations and check the display. Place
the CU in the location showing maximum number of bars (see
Figure 4.5:“Displayed Signal Strength and Coverage Area”). In the
event the number of bars is not changing, which is very possible,
choose a location that is most convenient.
Note: Each time the CU is moved, wait approximately 25 seconds for
the coverage area bars ( ) to stabilize.
Figure 4.5: Displayed Signal Strength
and Coverage Area
4.
Refer to page 7 for mounting instructions.