User Manual

MOUNTING THE DU AND CU
SpotCell
®
2500Xe 25
3.2 Mounting the CU
Find a suitable location to mount the unit that will provide good signal coverage. Refer to
section 2.4“Choosing a location for the CU”. The SpotCell 2500Xe CU is surface
mounted using the provided bracket and can be either mounted to a wall or hung from a
ceiling.
To mount the CU
1. Fasten the mounting bracket to the wall or ceiling.
If mounting on a solid wood surface, or stud covered by drywall, drill a 1/8th
inch diameter hole and then fasten the mounting bracket with #6 x 1.5” screws.
Figure 3.4: CU bracket fastened with screws
or
If mounting to drywall, drill a ¼ inch diameter hole, insert the screw anchors, and
then fasten the mounting bracket with 1/2” screws.
or
If mounting to a truss or t-bar, use the clips that are supplied with the optional
SpotCell Suspended Ceiling Mounting kit to hang the CU mounting bracket.
Figure 3.5: CU mount with T-bar clips