User Manual
Table Of Contents
Regulatory Notes and Statements
FCC Declaration of Conformity
This equipment complies with CFR 47, Part 15.19 of the
FCC rules. Operation of the equipment is subject to the
following conditions:
This device may not cause harmful interference; and
This device must accept any interference received,
including interference that may cause undesired
operation.
Information to the User for Class B Digital
Equipment
This equipment has been tested and found to comply with
limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna;
Increase the separation between the equipment and
receiver;
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected;
Consult the dealer or an experienced radio/TV
technician for help.
FCC Regulatory Compliance
This equipment has been tested and complies with the
following FCC requirements:
FCC Part 22, subpart H: Cellular Radiotelephone
Services.
FCC Part 24, subpart E: Broadband PCS.
FCC Part 15, subpart C - Intentional radiators.
Industry Canada Compliance
This equipment has been tested and complies with the
following requirements:
RSS - 131 - Zone Enhancers for Land Mobile Service.
ICES-003, Issue 4 - Interference Causing Equipment
Standard - Digital Apparatus
Health and Authorization for Use
SpotCell 2500Xe emits radio frequency electromagnetic
energy to enhance signals received by mobile devices for
in-building coverage. However, the energy level of these
emissions is by far much less than the electromagnetic
energy emitted by other wireless devices.
Caution! To maintain compliance with the FCC's RF
exposure guidelines, this equipment shall be installed and
operated with a minimum distance of 20cm between the
radiator and your body. Unauthorized modification of any
hardware and attachment may violate FCC regulations.
Warning! The use of shielded-type power cord is required
in order to meet FCC emission limits and to prevent
interference to nearby radio or television reception. It is
essential that only the supplied power cord be used. You
are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could
void your authority to operate the equipment.
Maximum Permissible Exposure Statement
The SpotCell 2500Xe is a low power repeater for in-door
coverage. The electromagnetic radiation emitted is much
less than what is specified by FCC. The product has been
evaluated under the FCC Bulletin Office of Engineering
Technology 65c - Evaluating Compliance with FCC
Guidelines for Human Exposure to Radio Frequency
Electromagnetic Fields. This equipment is complaint to the
requirements as set forth in the Code of Federal
Regulation 47, section 2.1091 (Radio frequency radiation
exposure evaluation), section 1.1310 (Radio frequency
Radiation Exposure Limits). Nevertheless, this
equipment shall be installed and operated with a
minimum distance of 20cm between the radiator and
your body. Use of this equipment in a body-worn manner
is strictly prohibited.
Safety Code 6 - Industry Canada Requirement
This equipment has been evaluated for radio frequency
Radiation limits in accordance with the Safety Code 6 -
Limits of Human Exposure to Radio frequency
Electromagnetic Fields in the Frequency Range from 3KHz
to 300GHz. The equipment is complaint to the safety code
6 requirements for the radiation limits as specified in
sections 2.1 and sections 2.2.
Safety Information
The CSA mark indicates that this Equipment meets the
CAN/CSA C22.2 N° 60950-00 and ANSI/UL Std N°
60950-00 - Safety of Information Technology Equipment.