User's Manual

INSTALLATION
9
7. Verify that the ZEN system is working by measuring the signal level (number of bars) near the
Coverage Unit and comparing it to that measured before the system was turned on in step 4.
Note: Your mobile phone must be at least 2 feet away from the Coverage Unit for the ZEN system to work
properly. The system will temporarily go into mute mode if a mobile phone is brought within 2 feet of the
Coverage Unit.
If there is no improvement in coverage, try pointing the Network Access Unit in a different
direction (away from the Coverage Unit).
You may have to try several different directions before seeing improved coverage.
8. Proceed to Mounting the Network Access Unit in the location and direction that showed the best
coverage.
Positioning the Network Access Unit Outdoors
It may not be possible to install the Network Access Unit indoors when installing the ZEN solution in
remote areas. If you are installing the Network Access Unit outdoors in a remote area, then an effort
should be made to mount the unit as high as possible.
Warning! Failure to properly ground an outdoor mounted Network Access Unit will leave the unit and
building vulnerable to damage from lightning strikes. Check local building and electrical code
requirements and comply with both local and national regulations.