User's Manual

INSTALLATION
13
Mounting the Coverage Unit
The Coverage Unit can be mounted to a wall or placed on a desk or shelf using the included cradle. If it
makes cable routing easier, you can also mount the Coverage Unit upside down with the cables
extending downward.
Mount the Coverage Unit only after the optimal location for the Network Access Unit has been determined
and the Network Access Unit has been mounted.
To mount the Coverage Unit on a wall
1. Find a suitable location to place the unit that will provide
good signal coverage, not blocked by any obstructions
and at least 2 feet away from where a mobile phone will
be used.
2. Fasten two screws to the wall, 3¼ inches vertically apart.
Leave approximately a ¼ inch gap between the head of
the screws and the wall.
3. Align the Coverage Unit’s two keyholes over the screws
and slide the unit down until it snaps into place.
4. Fit the cover onto the Coverage Unit.
To place the Coverage Unit on a desk or shelf
1. Find a suitable location to place the unit that
will provide good signal coverage, not on a
metal surface, not blocked by any
obstructions and at least 2 feet away from
where a mobile phone will be used.
2. Disconnect the coax cable from the
Coverage Unit.
3. Connect the 90º F-connector to the
Coverage Unit and connect the coax cable
to the F-connector.
4. Turn the Coverage Unit upside down and
align the two keyholes over the pins on the
stand.
5. Slide the unit down until it snaps into place.
6. Fit the cover onto the Coverage Unit.