SDS

Refer to attached safety data sheets and/or instructions for use. Stop leak if you can do so without
risk. Move the cylinder to a safe and open area if the leak is irreparable. Use water spray to reduce
vapors or divert vapor cloud drift. Isolate area until gas has dispersed. Eliminate all ignition
sources (no smoking, flares, sparks, or flames in immediate area). Keep combustibles (wood,
paper, oil, etc.) away from spilled material. Prevent product from entering drains. Following product
recovery, flush area with water. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all
environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into
drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing
or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke
while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. All equipment used when
handling the product must be grounded. Close valve after each use and when empty. Protect
cylinders from physical damage; do not drag, roll, slide, or drop. When moving cylinders, even for
short distances, use a cart (trolley, hand truck, etc.) designed to transport cylinders. Suck back of
water into the container must be prevented. Do not allow backfeed into the container. Purge air
from system before introducing gas. Use only properly specified equipment which is suitable for
this product, its supply pressure and temperature. Contact your gas supplier if in doubt. Do not
re-use empty containers. Avoid breathing gas. Avoid contact with eyes, skin, and clothing. Avoid
prolonged or repeated contact with skin. Use only in well-ventilated areas. Wear appropriate
personal protective equipment. Wash hands thoroughly after handling. Avoid release to the
environment. Observe good industrial hygiene practices.
Precautions for safe handling
Level 1 Aerosol.
Store locked up. Pressurized container. Protect from sunlight and do not expose to temperatures
exceeding 50°C/122 °F. Do not puncture, incinerate or crush. Do not handle or store near an open
flame, heat or other sources of ignition. This material can accumulate static charge which may
cause spark and become an ignition source. Store in a well-ventilated place. Cylinders should be
stored upright, with valve protection cap in place, and firmly secured to prevent falling or being
knocked over. Stored containers should be periodically checked for general condition and leakage.
Store away from incompatible materials (see Section 10 of the SDS). Level 1 Aerosol (NFPA 30B)
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
ValueComponents Type
PEL 1800 mg/m3Propane (CAS 74-98-6)
1000 ppm
US. ACGIH Threshold Limit Values
ValueComponents Type
STEL 1000 ppmButane (CAS 106-97-8)
US. NIOSH: Pocket Guide to Chemical Hazards
ValueComponents Type
TWA 1900 mg/m3Butane (CAS 106-97-8)
800 ppm
TWA 1800 mg/m3Propane (CAS 74-98-6)
1000 ppm
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Face shield is recommended. Wear safety glasses with side shields (or goggles).
Eye/face protection
Skin protection
Wear appropriate chemical resistant gloves. Suitable gloves can be recommended by the glove
supplier.
Hand protection
Wear appropriate chemical resistant clothing. Use of an impervious apron is recommended.
Other
3 / 10
Product name: 16 OZ SW GOOD NIGHT LT 12PK
Product #: 1000001195 Version #: 02 Revision date: 02-21-2017 Issue date: 10-27-2016
SDS US