User's Guide

Installing the keypad
WARNING: Your keypad sensor does not have the tamper resistant
bracket installed. You must place the bracket on the back of the
keypad.
IMPORTANT: Prior to installing on the wall,please test the arming and
disarming functions at the location where you decide to mount the
keypad,to ensure the wireless signal is sufficient to reach the siren hub
Do not install the keypad:
- Outdoors.
- Near large metal objects or mirrors as they can sometimes cause
radio signal interference.
- Near main wiring.
2.1 Decide upon your placement position and attach the bracket with
either screws (M) or double-sided adhesive tape (H) .
2.2 Hang the keypad (B) on the bracket (K) .
2
M
H
B
K
12

Installation
Montage des Sirenen Hub
WICHTIG: Achten Sie bei der Auswahl Ihres Standorts auf folgendes:
- Kann leicht gesehen werden, wenn der Blitz blinkt.
- Sie können den Alarm hören.
- Es gibt ein gutes drahtloses 2,4-GHz-Netzwerk.
- In der Nähe befindet sich eine Steckdose, die nicht über einen Wand-
schalter gesteuert wird.
1.1 Der Sirenen-Hub (A) kann an der Wand oder Decke montiert
werden.
1.2 Entfernen Sie die Halterung (AA) von dem Sirenen-Hub (A), indem
Sie sie gegen den Uhrzeigersinn drehen.
1.3 Bestimmen Sie Ihre Platzierungsposition und befestigen Sie die
Halterung (AA) entweder mit Schrauben (L) oder doppelseitigem
Klebeband (F).
A
A
1
A AAAAAA
/
GAA AA
31
