Instructions / Assembly

Assembly Instructions

MODEL #TC80485

Floor Lamp Assembly

1. Carefully unpack and lay out the parts as shown in the illustration.

2. Pull cord through base to tighten column connections.

3. Screw lower column into lamp base.

4. Screw second column into lower column.

5. Screw third column into second column.

6. Screw upper column into third column.

7. Screw shade holder into Upper Column.

8. Pull balance of cord from base to tighten excess.

9. Unscrew the shade ring from the socket,

place shade into the shade holder.

10. Replace the shade Ring onto threaded socket to secure the shade.

Uses Maximum 100Watt Type “A” Bulb.

(Bulb not included)

Cleaning of your lamp.

Unplug lamp, wipe with a damp cloth. Do not use abrasives.

*SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Made in China Revision – 10/05/16

FOR RETURN SHIPPING PURPOSES:

PLEASE RETAIN ORIGINAL PACKAGING

TO MINIMIZE DAMAGE.

PAGE 1
Assembly Instructions MODEL #TC80485 FOR RETURN SHIPPING PURPOSES: PLEASE RETAIN ORIGINAL PACKAGING TO MINIMIZE DAMAGE. Floor Lamp Assembly 1. 2. 3. 4. 5. 6. 7. 8. 9. Carefully unpack and lay out the parts as shown in the illustration. Pull cord through base to tighten column connections. Screw lower column into lamp base. Screw second column into lower column. Screw third column into second column. Screw upper column into third column. Screw shade holder into Upper Column.
PAGE 2
ASSEMBLY INSTRUCTIONS: Item No.: TC80485 FOR RETURN SHIPPING PURPOSES: PLEASE RETAIN ORIGINAL PACKAGING TO MINIMIZE DAMAGE. Table Lamp Assembly 1. Place the lamp on a level surface. 2. Insert the Harp into the saddle until it sits firmly into the saddle. 3. Screw knurl Nut on Harp. This can be used to raise the Finial Shade Knurl Nut Harp Shade a little if necessary. 4. Place the shade over the end of the harp and screw the Neck Finial securing the shade in place.