Instructions / Assembly
2
4
A
B
Disassembly
Insert the end of a screwdriver through the hole in the top of the anchor peg as pictured above.
Apply downward pressure on the screwdriver handle, liing the anchor peg partially out of the ground.
The anchor peg will now be loose enough to remove by hand. Alternatively, push the screwdriver all the way
through and use it as a handle while pulling upwards.
Repeat process on all remaining anchor pegs until removed. Do not discard pegs as these are reusable.
WARNING - Be aware of potential pinch points when using a screwdriver as a lever. Wear safety glasses
while preforming this procedure.
NOTE - If anchors have been installed for some time, soak the ground immediately around the anchor a day
or two prior to removal.