Installation Manual for Springfree O77 Trampoline Installing the tgoma can be challenging if you don’t carefully follow these instructions. To make it easier, we have demonstration videos that will guide you through each step. Visit www.tgoma.com/support to get started. Your Product Serial Number is: The information in this document is subject to change without notice. © Copyright tgoma NZ Ltd., 2016. All rights reserved.
WARNING Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep face clear of loaded rods. An improperly installed rod could release and cause facial injury or blindness. Never attempt to remove a black net rod from its net pocket or disengage (unlock) the rod sleeve while the black net rod is under tension. Do not hold onto, or place fingers between the rods while someone is jumping on the trampoline.
WARNING A. Please read the following precautions carefully before you assemble and use the trampoline, enclosure, and tgoma game system. B. Check all trampoline components for wear or damage prior to reassembly and use. C. Keep small children at least 25 ft (7.5 m) away while assembling or disassembling the trampoline; they could be injured by improperly assembled rods releasing and ejecting from the frame. D. Be aware that when loaded, the rods can spring back and may cause injury. E.
A 1 F H J B K I G B L M LOCATING TEMPLATE 5: Inside and Outside Person While the outside person holds the sensor top plate firm, position a sensor mount under the mat, flat side up. Align the sensor mount holes with the sensor top plate prongs. Press the two parts firmly together. 3: Outside Person C D E Place a sensor top plate in this hole, prongs down. Firmly push prongs through the gaps in the mat material until the sensor top plate is flat on the mat. Remove this template.
OUTSIDE VIEW INSIDE VIEW A 2 B NOTE - Have one person position themselves under the trampoline (hereafter known as the Inside Person) while the other person works around the outside of the trampoline (Outside Person). NOTE - Be sure to position the controller at the correct leg position, as indicated. If installed in the wrong location, you will be unable to complete the following steps correctly. Inside Person: Locate the nut on the back of the leg shown above.
3 OUTSIDE VIEW WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep your face well away from any loaded rod. WARNING - Do not use the trampoline unless it is completely assembled. Failure to follow these instructions may cause rods to break or eject from the trampoline frame. Outside Person: Remove the white c-clips located on the net rod sockets. Lift the bottom end of the black net rods out of the net rod sockets and lower the net.
4 OUTSIDE VIEW 2 3 LOCATING TEMPLATE 4: Inside Person 5: Inside and Outside Person While the outside person holds the sensor top plate firm, position a sensor mount under the mat, flat side up. Align the sensor mount holes with the sensor top plate prongs. Press the two parts firmly together. 3: Outside Person Place a sensor top plate in this hole, prongs down. Firmly push prongs through the gaps in the mat material until the sensor top plate is flat on the mat. Remove this template.
5 BOTTOM VIEW BEFORE TOP VIEW BEFORE BOTTOM VIEW AFTER TOP VIEW AFTER WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep your face well away from any loaded rod. NOTE - Be sure not to fasten the small cable ties during this step. Inside Person: Feed a small cable tie up through one of the holes in the sensor mount. Outside Person: Pull the cable tie across the channel and down through the corresponding hole.
INSIDE VIEW OUTSIDE VIEW 6 2 3 1 4 WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep your face well away from any loaded rod. Inside Person: Starting at sensor position 2, locate the first mat rod holder to the left. Install a cable clip at the front of the mat rod holder pocket, as shown. Inside Person: Moving to the left around the trampoline, install ONE cable clip in front of each mat rod holder pocket between sensor positions 2 and 1.
INSIDE VIEW OUTSIDE VIEW 7 A B 2 3 1 4 BOTTOM VIEW BEFORE A B BOTTOM VIEW AFTER NOTE - Before proceeding, double check that each cable clip is pushed fully onto the edge of its pocket and that there are no cable clips installed in front of any of the sensor positions. TIP - If you are having trouble inserting the cable sensors into the sensor mounts, try flipping them over. They are designed to only fit one way.
OUTSIDE VIEW 8 1 2 WANT TO ENVIE DE SAUTER? AT A TIME. IT SAFE! ONE FOIS. UNE À LA JUMP? DO SÉCURITÉ! EN TOUTE FAITES-LE WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep your face well away from any loaded rod. WARNING - Never attempt to remove a black net rod from its net rod pocket or disengage (unlock) the rod sleeve while the black net rod is under tension.
9 INSIDE VIEW INSIDE VIEW INSIDE VIEW A B B A A A B B B NOTE - Cable A with the yellow tag must be plugged into socket A and cable B with the white tag into socket B. The cable plugs and controller sockets are ‘keyed’ (ie, they will only fit correctly in one position). Line up the green post in the cable plug with the slot in the controller socket. Do not force the plug into the socket; when you have correctly keyed them they will slide together easily.
10 WARNING - Treat any loaded rod with caution until you are sure it is properly installed or uninstalled. Keep your face well away from any loaded rod. NOTE - Ensure the tablet holder is in the correct orientation. TIP - The software’s default position for the tablet holder is opposite the door. Consult your Software User Guide for how to position the tablet holder in alternative locations.
11 Minimum Tablet Specifications Apple ® Tablets: • iPad 3 or more recent, iPad Mini & iPad Air. • Bluetooth® 4 (also known as LE) or more recent (NOTE: iPads 1 and 2 cannot be used because they do not have Bluetooth 4). • Tablets with screen size between 7” and 11” (not phones). • Android operating system 4.4 or more recent. Android TM Tablets: • Bluetooth 4 (also known as LE) or more recent. • Tablets with screen size between 7” and 11” (not phones).
12 Installation Manual for Springfree Trampoline Installing the tgoma can be challenging if you don’t carefully follow these instructions. To make it easier, we have demonstration videos that will guide you through each step. Visit www.tgoma.com/support to get started. Your Product Serial Number is: Your serial number is located on the front of manual. The information in this document is subject to change without notice. © Copyright tgoma NZ Ltd., 2016. All rights reserved.
13 WARNING - To protect the batteries store the battery pack indoors when not in use. NOTE - When you turn the controller on to connect to your tablet, ensure there is nobody standing/sitting on, or leaning against, the trampoline for 15 seconds. This allows the controller to correctly set the sensors for accuracy. This wait time should be observed each time after the trampoline is moved. TIP - tgoma is designed to work across a wide range of tablets.
14 WARNING - Do not leave your tablet outside in wet weather. Once you have completed setting up your tgoma on your tablet, hold your tablet in a landscape orientation and place the bottom edge onto the bottom jaw of the clamp. Pull the tablet down on the bottom jaw until the clamp opens wide enough for the tablet to fit between the top and bottom jaws of the clamp. Push the tablet back into position, and release. Hook the tablet holder onto the inside of the trampoline net, opposite the entrance.
15 Games: where your games and apps live once you’ve downloaded them. JumpFit: where you access your jump stats via the JumpTracker, or set goals to achieve. News & Events: where you see news and events to participate in. Settings: where you set up tgoma (make sure you select your trampoline model in General Settings before using it). Store: where you preview all the games and apps available. New games are added frequently so check this area regularly. Users: tap this to create a new user.
PRODUCT SPECIFICATION TABLE Name of product as described in the marketing literature tgoma Game System Part number(s) TGR54000, TGR79000, TGO77000, TGO92000, TGS113000, TGS155000 Operating temperature range 0°C to +40°C (+32°F to +104°F) Storage temperature range 0°C to +40°C (+32°F to +104°F) Operating humidity 10% to 90% non-condensing RF Compliances Part Safety agency approvals FCC class B; IC class B; EN/CE class B Power 4 x user supplied AA (alkaline preferred) batteries TBD but UL60950
tgoma® Game System Limited Warranty DO NOT USE YOUR PRODUCT UNTIL YOU HAVE READ THE TERMS OF THE WARRANTY. IF YOU DO NOT AGREE TO THE TERMS OF THE WARRANTY, DO NOT USE THE PRODUCT AND RETURN IT WITHIN 7 DAYS TO THE STORE OR THE AUTHORIZED DISTRIBUTOR WHERE YOU PURCHASED IT FOR A REFUND. WHAT IS COVERED tgoma NZ Ltd. and its authorized service partners warrant this product against original defects in material and workmanship for a period of ONE (1) YEAR.