User Manual

26
Operating manual moden
1. Insert the plug into a power socket. If
Nina is in standby mode, reactivate it
by pressing any button.
2. Assemble the appliance.
3. Press the Scale/Tare button to set the
scale back to 0.
4. Place the ingredients in the mixing
container and then close the lid.
5. Press Knead.
6. Allow the liquid to slowly flow into the
mixing container via the holes in the lid.
7. The programme ends automatically
after 6 minutes.
8. Press Start/Reset.
9. Press Extrude. Nina will now begin
pressing out the pasta. It stops
automatically.
Pausing or cancelling the
programme
To pause a programme, simply open the
lid. The programme will continue once you
close the lid again.
To cancel a programme, press and hold the
Start/Reset button for about 3 seconds.
Cleaning and care
Nina should be cleaned and dried after
each use as follows. Lack of or improper
care of the appliance can impair the
functionality of the appliance.
• The appliance is easiest to clean when
you first allow the dough remains to
dry out. You can then remove them
easily using the rubber spatula.
• Clean all plastic parts on the top shelf
of a dishwasher and use a programme
with at most 60 °C to keep them from
losing their shape. Make sure that the
plastic part is not jammed.
• It is possible for flour to end up
between the extruder screw and the
mixing arm, or between the mixing
arm and the appliance, causing the
appliance to make screeching sounds.
Make sure these parts are cleaned
thoroughly.
• Clean the appliance using a damp
cloth. It must not be submerged in
water or cleaned under running water.