Assembly Manual A 1 B 1 C 1 Backrest E1 2 D 1 Seat Cushion E2 2 Swivel Plate 3 H5 3 3 Spring Washer Bolt M8X80mm H7 1 F Back Cushion Back Cushion cover Inner 3 H4 Seat Board Storage Body Flat Washer H6 4 4 Nut T-Nut M6X16mm Flat Washer Spring Washer Allen Wrench Open End Wrench 4 Page 2 of 7
Assembly Manual 3 Rotate the Swivel Plate (F) by 45 degrees. 45° Rotate the Swivel Plate by 45 degrees. F 4 Turn over the storage base, attach the Swivel Plate (F) to Storage Body (B), using Bolts (H5), Spring Washers (H7),and Flat Washers (H6). Note: Loosely attach the bolts one by one and keep them loose. Do not fully tighten. After all 4 bolts are attached, use Allen Wrench (T1) to tighten.
Assembly Manual 5 Attach the Bolts (H1) to the Storage Body (B), and fully tighten all of them. H1 B 6 Attach the Backrest (A) to the Storage Body (B), using the Bolts (H1), the Flat Washers (H3), the Spring Washers (H2), and the Nut (H4). Note: Loosely attach the nuts one by one and keep them loose. Do not fully tighten. After all the 3 nuts are attached, use Open End Wrench (T2) to tighten.
Assembly Manual 7 Put the Seat Board (C) onto the Storage Body (B). The handle is at the inside of the backrest. C B 8 Put the Seat Cushion (D) onto the Seat Board (C). The zipper is on the inside of the backrest.
Assembly Manual 9 Put the Back Cushion Inner (E2) into the Back Cushion Cover (E1), then zip it up. Put the Back Cushions (E) onto the Chair. E1 E E2 10 Assembly complete, it's ready to use.
