Assembly Manual BS72022 BS72022 Assembly Manual Counter & Bar Height Swivel Stool CAUTION THIS ASSEMBLY MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Assembly Manual BS72022 AX1 BX1 Metal Back Bracket DX1 CX1 EX1 FX1 Leg Footrest HX1 GX1 Swivel Plate JX6 Allen Wrench (M4) PX6 Bolt ( 1/4'' x 35mm) Open-Ended Wrench LX6 Nut ( 1/4'' ) Flat Washer Spring Washer Bolt ( 1/4'' x 12mm) Seat Cushion IX1 K X 12 MX8 Leg Wood Back Panel NX3 OX4 Bolt ( 1/4'' x 30mm) QX4 Felt Pads (φ19mm) Bolt ( 1/4'' x 30mm) Extra Hardware Touch-up Pen Please read through the instructions below to familiarize yourself with the parts and steps before assem
Assembly Manual BS72022 ASSEMBLY INSTRUCTIONS Note: Assemble on a soft and smooth surface to prevent damage to product finish. Do not overtighten bolts to avoid stripping. 1 Connect Leg (C) and Leg (D) together. Attach Footrest (E) to stool base, using Bolts (O) and Allen Wrench (H). Note: Do not fully tighten bolts. D D C E E O O H 2 Attach Swivel Plate (G) to assembled stool base in Step 1, using Bolts (M). After all 4 bolts are attached, use Allen Wrench (H) to tighten.
Assembly Manual BS72022 3 Attach Metal Back Bracket (A) and Wood Back Panel (B) together, using Bolts (N). After all 3 bolts are attached, use Allen Wrench (H) to tighten. Note: 1. Please pay attention to the direction of the Wood Back Panel (B). Note: 2. Do not fully tighten bolts. UP B B UP N N A H 4 Attach Metal Back Bracket (A) to Seat Cushion (F), using Bolts (P), Flat Washers (K), Spring Washers (J), Nuts (L), Allen Wrench (H), and Open-Ended Wrench (I). Note: Do not fully tighten bolts.
Assembly Manual BS72022 5 Attach assembled stool base in Step 2 to assembled seat in Step 3, using Bolts (M). After all 4 bolts are attached, use Allen Wrench (H) to tighten. Fully tighten bolts. H M 6 Put assembled stool on a flat surface. Push legs up or down as necessary to level. Once level, tighten all bolts. Note: Each leg has an adjustable foot leveler to help level your chair. Touch-up Pen has been provided to repair any small nicks or scratches that may occur during assembly or shipping.
Assembly Manual BS72022 7 Complimentary Felt Pads (Q) are included to help protect your floor or make the chair slide easier. If needed, attach the complimentary Felt Pads (Q) to the leg. Q 8 Assembly complete. Enjoy.
Assembly Manual BS72022 PRODUCT WARRANTY · 1-year limited on cover against splitting, peeling, and/or tearing. · 1-year limited on internal and external frame structure. · 1-year limited on cushioning material, seat springs and mechanism. CARE & MAINTENANCE Water Based Cleaner ‘W’: Spot clean using the foam only from a water-based cleaning agent such as a mild detergent or non-solvent upholstery shampoo product. Apply foam with a soft in circular motion. Vaccum when dry.
