Assembly Manual BS71286 BS71286 Assembly Manual Swivel Bar & Counter Stool CAUTION THIS ASSEMBLY MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Assembly Manual BS71286 AX1 BX2 CX2 DX2 Ex2 H1 x 8 (Long) (Short) H2 x 8 H3 x 8 Bolt (M8x60mm) H5 x 4 Foot Leveler (M6xH30mm) Screw (M5x50mm) H4 x 8 Spring Washer (M8) Flat Washer (φ8) Allen Wrench (5#) Not Included T1 x 1 Before you begin: 1. Check if you have received all parts using the diagram on this page. Do not start the assembly process until all parts are present.
Assembly Manual BS71286 1 Attach Legs (B & C) to Seat (A), using bolts (H2), lock washers (H3), flat washers (H4), and allen wrench (T1). Note: Do not fully tighten yet. B B C H2 H3 H4 A B B C 2 Insert short side rails (D) and long side rails (E). Note: You may need to apply a little pressure to enable the rails to slot into position.
Assembly Manual BS71286 3 Attach the rails using screws (H1). Do NOT start the screws if the rails are not fully slotted into position. Note: Do not fully tighten yet. H1 Note: Do NOT start the screws if the rails are not fully slotted into position. 4 Attach foot levelers (H5) to Legs (B & C).
Assembly Manual BS71286 5 Turn assembled chair upright and place on a flat surface. Push legs up or down as necessary to level. Once level, tighten all bolts and screws. Note: Each leg has an adjustable foot leveler to help level your chair.
Assembly Manual BS71286 6 Assembly complete. Enjoy. CAUTION: PINCH POINT. Please keep hands clear during swivel.
